A&D UB-1100BLE Instruction Manual page 22

Visitor Mode Measurement
1. Press the Start button on the monitor.
2. Press the Start button again to switch between username from User Select "0 Visitor".
3. The C.P.G. indicator will display the correct wrist position briefly. Measurement starts automatically after 3 seconds.
4. When the measurement is complete, the monitor will display result similar to the icon on the right.
(Systolic, diastolic and pulse rate will be displayed in rotation.)
Visitor Mode is only available through the monitor. Data is not stored in visitor mode.
Notes for Accurate Measurement
Sit down in a comfortable position. Place your arm on a table with your palm facing upward and the cuff at the
same level as your heart.
Relax for about five or ten minutes before taking a measurement. If you are excited or depressed by emotional
stress, the measurement will reflect this stress as a higher (or lower) than normal blood pressure reading and the
pulse reading will usually be faster than normal.
An individual's blood pressure varies constantly, depending on what you are doing and what you have eaten.
What you drink can have a very strong and rapid effect on your blood pressure.
This device bases its measurements on the heartbeat. If you have a very weak or irregular heartbeat, the device
may have difficulty determining your blood pressure.
Should the device detect a condition that is abnormal, it will stop the measurement and display an error symbol.
See page 7,8 for the description of the symbols.
This blood pressure monitor is intended for use by adults. Consult with your physician before using this device on
a child. A child should not use this device unattended.
The automatic blood pressure monitor's performance may be affected by excessive temperature or humidity, or
altitude.
Measurements
English 20