Transfer Position Indicator Does Not Come On At Ignition Switch On But Engine Stops - Suzuki GRAND VITARA JB416 Service Manual

Hide thumbs Also See for GRAND VITARA JB416:

Table of Contents

3C-25 Transfer: Motor-Shift Type (Transfer with Shift Actuator)

Transfer Position Indicator Does Not Come ON at Ignition Switch ON but Engine Stops

Wiring Diagram

[A]: 4WD control module connector "E91" (viewed from harness side)

[B]: Combination meter connector (viewed from harness side)

1. 4WD control module

2. Combination meter

3. Differential lock indicator

Circuit Description

Transfer position indicator operates according to the signal from 4WD control module. If the transfer control system is

in good condition, transfer position indicator light up for 2 seconds when ignition switch is turned to ON position, and

then turned to OFF position. If an abnormality is detected in the system, transfer position indicator remains lighting.

4. 4L indicator

5. N indicator

6. Junction block assembly

7. "METER" fuse

8. Ignition switch

S5JB0E3314012

I5JB0A332015-03

Grand vitara jb420