HP XW9400 Hardware Setup Manual page 25

To verify the AJA PCI-X firmware version:
1 Open a terminal, and type:
cat /proc/driver/aja
An output similar to the following should appear:
AJA Driver Name: oem2k
Version: 4.1 Beta 11
Card #: 0
Board Version String: OEM 2K - Rev 0
PCI Version: 0x55
Board ID: 10196500
FPGA built on 2007/09/18 at 10:57:41
NOTE If there is no aja file in /proc/driver, you are using an outdated driver
or the driver is not loaded and you must install the latest DKU for your
workstation. Refer to the Autodesk Visual Effects and Finishing Software
Installation Guide.
Updating the AJA PCI-X Firmware
The firmware on your AJA PCI-X must correspond to the certified version
required by your Visual Effects and Finishing application version. If you verified
the firmware on your AJA PCI-X and it did not match the certified version,
you must update it. The following procedure describes how to update the
firmware of the AJA PCI-X to the certified version required by your Visual
Effects and Finishing application.
To update AJA PCI-X firmware:
1 Log in as root and open a terminal.
2 Insert the application DVD in the DVD-ROM drive of the workstation,
and mount it.
3 Go to the DKU_
of the DVD,
where
<version_number>
example:
cd /mnt/cdrom/DKU_3.0.0/Utils/AJA_firmwareUpdate
<version_number>
represents the version of the DKU. For
/Utils/AJA_firmwareUpdate directory
AJA OEM-2K PCI-X Firmware | 17