HP XW9400 Hardware Setup Manual page 22

System configuration is done prior to delivery by an authorized technician.
The following procedures may not be necessary, and are provided here for
informational purposes only.
Verifying DVI-Ramp and DVI-Ramp2 Firmware
The firmware on your DVI-Ramp must correspond to the certified version
required by your Visual Effects and Finishing application version. Each
firmware is itself associated to a DVI-Ramp version and a hardware version.
If the firmware on your DVI-Ramp does not match the hardware version listed
in the table below, you must update the firmware to the certified version.
Visual Effects and Finishing
Application Version
2009 with
The DVI-Ramp firmware update utilities required to check your firmware
version and perform the update are included with the DKU version associated
with the release of your Visual Effects and Finishing application. The following
procedure describes how to verify the firmware version of the DVI-Ramp.
To verify the firmware version of the DVI-Ramp:
1 With the DVI-Ramp connected to your workstation and powered up,
open a terminal, and log in as root.
WARNING If your DVI-Ramp is connected to the HP workstation using a
USB-to-Serial adapter, you must remove the adapter from the USB port, and
connect the serial cable of the DVI-Ramp to the serial port of the workstation.
This does not apply to DVI-Ramp2 units.
2 Insert the application DVD in the DVD-ROM drive of the workstation
and mount it.
3 Go to the DKU_
on the DVD,
where
cd /mnt/cdrom/DKU_3.0.0/Utils/DVI_firmwareUpdate
14 | Chapter 2 Getting Started
Hardware Version
DVI-Ramp 3.20
DVI-Ramp 4.20
DVI-Ramp2 6.00
<version_number>
<version_number>
Certified Firmware Ver-
sion
3.70
4.71
6.0506
6.0507
6.0508
/Utils/DVI_firmwareUpdate directory
is the DKU version. For example: