Manual Configuration; Installation - D-Link DAP-3666 Quick Installation Manual

1
Figure 3: Rear Connectors
# Connector
Grounding
Connector for the grounding wire.
1
Wire
Mount to connect to the
Wall/Pole
2 mounting plate on a wall or
Mount
a pole.
Table 3: Interface Description

Installation

The DAP-3666 can be powered using one of the
following two methods:
Using Power over Ethernet (PoE)
1. Use a standard Ethernet cable to connect
the LAN1(PoE) port on the DAP-3666
to a PoE power source device such as
an 802.3af or 802.3at PoE switch or PoE
injector.
2
2
Description
Configuration
Using Nuclias Connect
The DAP-3666 is designed to be managed
through Nuclias Connect. Refer to the Nuclias
Connect Manual for detailed configuration
instructions.

Manual Configuration

Note: D-Link recommends manually configuring
the device before mounting it. The management
computer, DHCP server and DAP-3666 must be
in the same subnet.
Use one of the following methods to access the
web user interface:
Connecting through Ethernet
1. Use an Ethernet cable to connect the
DAP-3666 to the management computer,
or to the switch or router the management
computer is connected to.
2. Manage the access point from a computer.
Enter dap3666.local in the address field
of your browser.
3. Log in to the administration user
interface. The default login information is
Username: admin
Password: admin
Connecting Wirelessly
1. Connect the management computer to
the default SSID of the DAP-3666, "dlink".
2. Manage the access point from a computer.
Enter dap3666.local in the address field
of your browser.
DAP-3666 Quick Installation Guide