Acoustic Alarm; Automatic Start Of The Station Seek Operation (Tape Playback); Adjusting The Volume Of Traffic Messages And The Acoustic Alarm; Tape Section - Blaupunkt RHODOS CC 25 Operating Instructions Manual

Acoustic Alarm

When leaving the coverage area of the tuned
in traffic station, your car radio automatically
sends out an acoustic alarm after approxima-
tely 30 seconds.
This alarm tone can also be heard when
pressing a preset button with no ARI station
allocated to it.
For switching off the acoustic alarm,
• search for a new station (see chapter
"Tuning in a Station Automatically").
The set will then start searching for the
next traffic station.
Automatic Start of the Station
Seek Operation (Tape Playback)
When leaving the coverage area of the tuned
in traffic station, your car radio will automati-
cally start searching for a new traffic station
while you are listening to your tape.
Adjusting the Volume of Traffic
Messages and the Acoustic
Alarm
This volume has been set ex factory. Howe-
ver, you can adapt it according to your perso-
nal preferences.
• Tune in to a traffic information station
("SK" ; is displayed).
Activate the ARI function by
presdsing the ARI rocker switch @.
•
• Turn the volume down.
Using a suitable screwdriver (maximum bla-
de width 2 mm), you can carefully (!) adjust
the volume while a traffic message is broad-
cast (fig. 2).
For this, the set has to be connected and
pulled out of the installation compartment.

Tape Section

Inserting a Tape

If you want to listen to a tape:
• Switch on the set.
• Insert the cassette into the slot with the
tape side showing to the right and the
empty reel to the front.

Fast Forwarding the Tape

Fast Forward Operation
Briefly press the FF button 6.
•
Stopping Fast Forward Operation
Briefly press the FF button 6.
•

Removing the Tape

To stop tape play:
button 6 firmly.
• Press the
The cassette is ejected.
19