U-Line H-6651 Manual page 2

5. Attach high pressure hose to spray gun. (See Figure 5)
Figure 5
6. Push on right side of spray gun to lock trigger. Push
on the left side of the spray gun to unlock trigger.
(See Figure 6)
NOTE: Always make sure the spray gun is
locked when not in use.
Figure 6
Press to
Lock
1
2
Trigger
7. To connect nozzle to spray gun, insert nozzle into
spray gun, push together and at the same time twist
clockwise to lock in place. To remove, push together
and twist counterclockwise then pull apart.
(See Figure 7)
Figure 7
PAGE 2 OF 12
ASSEMBLY CONTINUED
Press to
Lock
1
2
Trigger
8. The high/low nozzle has two positions:
IN position – For high pressure spray. Designed for
cleaning and allowing spray to be adjusted.
OUT position – For low pressure spray for detergent
function. Spray needs to be set with fan blades in
the "pencil stream" position to assure the detergent
is not restricted. (See Figures 8-9)
Figure 8
Fan Spray
Pencil Stream
Figure 9
Pencil Stream
9. Fill detergent tank. (See Figure 10)
NOTE: Do NOT use thick detergent, as it can
clog the power washer.
10. Pull clear siphoning tube through cap so it will draw
detergent from the bottom of the tank. (See Figure 11)
IN position
High Pressure Setting
OUT position
Low Pressure Setting
Figure 10
Figure 11
0617 IH-6651