Auto Or Carbon Setting - Toshiba Strata CIX IP5000-UG-VC User Manual

Headset and Handset Operation

AUTO or CARBON Setting

AUTO or CARBON Setting
There exist two types of headsets: ECM and Carbon. The default setting on the
telephones is AUTO. When the headset is connected to the Headset Modular
Connector of the telephone, the AUTO setting enables the headset I/F current detector
to determine which headset type is connected (EMC or Carbon). If the current is
marginal using a carbon headset (only) and performance is not good, change the
setting to CARBON.
 To change the setting from Auto to Carbon
Telephones: All except the Single Line Telephone
1. Press
2. Press
3. Press
Press
FB LED On: CARBON
FB LED Off: AUTO (default)
4. Press
5. Go off-hook, then on-hook to exit the program mode.
 To change the headset transmit sensitivity level to Low or Normal
1. Press
2. Press
3. Press
4. Press
FB LED On: Low
FB LED Off: Normal (default)
5. Press
6. Go off-hook, then on-hook to exit program mode.
110
3+6+9+Hold
(simultaneously).
0
.
FB6
to toggle Handset On/Off.
FB11
to toggle Headset On/Off.
Hold
to set the option.
3+6+9+Hold
(simultaneously).
0
.
Hold
.
FB12
to toggle On/Off.
Hold
to set the option.
Strata CIX IP5000-series Telephone UG 07/09