Daily Maintenance (While Stove Is In Use); Remove Ash (If Necessary); Clean The Glass (If Necessary) - Lopi Answer Manual

34
Failure to properly maintain and inspect your appliance may reduce the performance and life of the appliance,
void your warranty, and create a fire hazard.
Establish a routine for the fuel, wood burner and firing technique. Check daily for creosote build-up until
experience shows how often you need to clean to be safe. Be aware that the hotter the fire the less creosote
is deposited, and weekly cleaning may be necessary in mild weather even though monthly cleaning may be
enough in the coldest months. Contact your local municipal or provincial fire authority for information on how
to handle a chimney fire. Have a clearly understood plan to handle a chimney fire.

Daily Maintenance (while stove is in use)

Remove Ash (if necessary)

Whenever ashes get 3 to 4 inches deep in your firebox or ash pan, and when the fire has burned down
and cooled, remove excess ashes. Leave an ash bed approximately 1 inch deep on the firebox bottom to
help maintain a hot charcoal bed. Let the stove cool completely before removing ashes (wait at least two
hours after the last coal has extinguished). Ashes should be placed in a metal container with a tight-fitting
lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, away
from all combustible materials, pending final disposal. The ashes should be retained in the closed
container until all cinders have thoroughly cooled.

Ash removal is not required once it builds up. 1/2" to 1" of ash may be desirable because it slows the
burn rate. Generally, remove ash once it has built up over 1". Follow the directions below to remove
ash.
1 Let the stove cool completely (at least two hours after the last coal has extinguished).
2 Place a cloth or cardboard protector over the hearth to catch ash and protect against
scratching.
3 Open the doors and scoop the ash into a metal container with a tight fitting lid. The closed
container of ashes should be placed on a noncombustible floor or on the ground, away
from all combustible materials, pending final disposal.
Improperly disposed ashes lead to fires. Hot ashes placed in cardboard boxes, dumped in back yards,
or stored in garages, are recipes for disaster.
Wood-burning stoves are inherently dirty. During cleaning have a vacuum ready to catch spilled ash
(make sure ash is entirely extinguished).
There are vacuum cleaners specifically made to remove ash (even if the ash is warm). Contact your
dealer for details.

Clean the Glass (if necessary)

This appliance has an air wash to keep the glass
clean. However, burning un-seasoned wood or
burning on lower burn rates leads to dirtier glass
(especially on the sides). Clean the glass by
following the directions below. Do not clean glass
with abrasive cleaners.

Allow the stove to fully cool.

Apply glass cleaner or soapy water to the
inside of the glass.

Wipe with newspaper or a paper towel.
NOTE: for stubborn Creosote, dip newspaper or a
paper towel in cool ashes and wipe it on the
glass. The ash acts as a light abrasive.
The glass will develop a very slight haze over time. This is normal and will not affect viewing of the fire.
© Travis Industries
Maintaining Your Appliance
4/20/2020 - 1510
ASHES
IDB1143
Answer