Panasonic KW4M User Manual page 18

VT ratio setting mode
・Enter VT ratio using<kW/kWh>,< A >,< V >,<CHARGE>.
・ If the VT is 440/110, set to " 4.00 ".
Current for time measurement setting mode
・ Enter current for time measurement using
・ If you measure the current over 50.0%F.S, set to " 50.0 ".
Cutoff current setting mode
・ Enter cutoff current using <kW/kWh> ,< A >,< V >.
・If you don't measure the current under 10.0%F.S,
set to " 10.0 ".
Unit for pulse output setting mode
・ Press <kW/kWh> to change unit for pulse output.
・Unit is selected from
0.001→0.01→0.1→1→10→100 →ALARM.
Alarm value setting mode
・ Enter power for alarm using
<kW/kWh>,< A >,< V >,<CHARGE>,<TIME>,<COUNT>.
*It is only when " ALARM " is selected on unit for pulse
output setting mode.
Electricity charge setting mode
・Press <COUNT> to change
JPY→＄→EUR→CNY→CHG→CO2.
・Enter the rate per 1kWh using
12
（1.00～99.99）
<kW/kWh>,< A >,< V >.
（1.0～100.0）
（1.0～50.0）
（0～9999.99kWh）
<kW/kWh>,< A >,< V >,<CHARGE>.
Normal display
Factory setting / Display
↓ <SET>
Factory setting / Display
↓ <SET>
Factory setting / Display
↓ <SET>
Factory setting / Display
↓ <SET>
Factory setting / Display
↓ <SET>
Factory setting / Display
↓ <SET>