Chapter 5 Settings; Operation Procedure - Panasonic KW4M User Manual

Chapter 5 Settings

5-1 Operation procedure

Each setting is classified as follows. There are the detailed explanations from next pages.
・MODE:<MODE>
...Mode for selection of Power measurement (Power meter) or Pulse measurement (Pulse counter).
・MODE1: <MODE>+<kW/kWh> ... Mode for setting each parameter for power measurement.
・MODE2: <MODE>+<A> ... Mode for setting of each parameter for pulse measurement
・MODE3: <MODE>+<V> ... Mode for setting of each parameter for serial communication (RS-485)
・MODE4: <MODE>+<CHARGE> ... Mode for setting of each parameter for optional function
(MODE 1)＊1
<kW/kWh>
CT type setting mode
C T - T
<SET>
Primary side current of
CT setting mode
C T -1
＊3
<SET>
VT ratio setting mode
V T
<SET>
Current for time
measurement setting mode
H -A
SET キー
Cutoff current setting mode
C U T A
<SET>
Unit for pulse output
setting mode
P L-P
<SET>
Alarm value setting mode
A L-P
＊4
<SET>
Electricity rate setting mode
 P Y/ $ /E U R / C N Y/ C H G / C O 2
<SET>
＊1 MODE1 is only for POWER measurement.
＊2 MODE2 is only for PULSE measurement.
＊3 Primary side current of CT setting mode is only for when '5A' is selected on CT type setting mode.
＊4 Alarm value setting mode is only for when 'ALARM' is selected on Unit for pulse output setting mode.
NOTE） Power measurement (Power meter) and Pulse measurement (Pulse counter) can not
be used at the same time.
Normal Display
 O  E
(MODE 2)＊2
<A>
Max.measurement speed
setting mode
H z
<SET>
Pre-scale setting mode
P S C L
<SET>
Unit setting mode
U N I T
<SET>
Normal display
<MODE>
<MODE>
<SET>
(MODE 3)
<V>
Station number setting
mode
N O .
<SET>
Transmission speed
setting mode
S P 
<SET>
Transmission format
setting mode
F  T
<SET>
Response time
setting mode
R E S P
<SET>
Note)
Press <MODE>to
return normal display.
(MODE)
Continuous press
about 3sec.
Input method setting mode
I N
(MODE 4)
<CHARGE>
Auto-off setting mode
O F F
<SET>
9