Playback; Head; Stop; Trk Reset - Toshiba W-705 Owner's Manual

PLAYBACK

Playback
This section explains the basic playback operation.
Preparation
• Select the video channel (3 or 4) or video input mode on the TV.
• Press VCR to set the remote control operating the VCR.
VCR
1 2 3
4 5 6
REW
TV/VCR
+
7 8 9
8
– 2
9
0
- FF
( )
3
a J
L
19

TRK RESET

PROG

TRACKING

Adjusting the tracking
When playback starts, the VCR automatically
adjusts the tracking for clear pictures and sound
(Digital Auto Tracking).
The "DT" indicator blinks during the adjusting.
If the VCR cannot locate the best possible
tracking point, hold down one of TRACKING to
adjust the tracking manually.
• To resume the digital auto tracking, hold down
both CHANNEL on the VCR simultaneously for
about 2 seconds.
Notes
• During the adjusting, the playback picture and
sound may be distorted.
• The digital auto tracking is activated only in the
playback mode.
• To reset the manual tracking point to the center,
press both CHANNEL on the VCR
simultaneously or TRK RESET for not longer
than 1 second.
• The noise on the screen may not be completely
eliminated depending on the tape used,
especially when the tape was recorded on
another VCR.
Basic Playback
1
Load a recorded cassette.
Power is turned on.
If the cassette has no safety tab,
playback starts automatically.
2
Press PLAY to start playback.
3
To stop playback, press STOP .
Rewinding / Fast-forwarding
Press REW or FF in the Stop mode.
19
You can view high quality pictures while playing
back a tape recorded in the SLP tape speed.
By pressing 19 repeatedly, the 19 HEAD mode
is displayed on the TV screen as follows:
19U-HEAD AUTO: Usually set to "AUTO". As the
playback starts, the VCR automatically activates
the 19 head and reproduces high quality pictures.
19U-HEAD OFF: Set to "OFF" if the pictures are
marred by dots.
Note
During playback with the 19 head, momentary
noises or shakes may be produced when you
change the mode to the picture search or
variable speed playback.
POWER
POWER
S P
VCR

HEAD

DT
2 1