Adjusting the Lens
Based on the live image retrieved from the camera, adjust the camera lens by doing the
following:
To adjust the viewing angle -- 3-axis mechanism design
1. Loosen the pan adjustment screw and then turn the lens module left and right. Upon
completion, tighten the screw.
2. Loosen the tilt adjustment screws on both side of the camera and then turn the lens
module up and down. Upon completion, tighten the screws.
3. Loosen the rotation adjustment screw and then turn the lens to adjust the image
orientation. Upon completion, tighten screw.
Rotate the screw
Turn the lens
Loosen
Pan 350°
To adjust the zoom factor and focus range
1. Loosen the zoom controller to adjust the zoom factor. Upon completion, tighten the
zoom controller.
2. Loosen the focus controller to adjust the focus range. Upon completion, tighten the
focus controller.
DO NOT overrotate the lens. Doing so will damage the camera lens module.
The sophisticated 3-axis mechanism design offers very flexible,
easy hardware installation for either ceiling or wall mount.
Do not tighten the tilt adjustment
screws too much by screw driver.
Doing so will damage the tilt
mechanism.
1
Tighten
Loosen
Loosen
Tighten
2
Tighten
Tilt 85°
Loosen
3
Tighten
Rotate 350°
W
T
N
21
21