Connecting The Signals - National Instruments TBX-1329 Installation Manual

Connecting the Signals

Note Refer to
disconnecting any signal wires.
2
1
14
1 Current Loop Receiver Resistor
2 Safety Ground Solder Lugs
3 Product Name
4 Assembly Number
© National Instruments Corporation
Safety Information
When connecting your signals to the TBX-1329, follow the labeling on the
TBX-1329 for the appropriate module, as indicated in Figure 1. When
using the TBX-1329 with the SCXI-1125 or SCXI-1126, follow the
SCXI-1120/1120D labeling.
3
300V MAX CHANNEL TO CHANNEL
300V MAX CHANNEL TO EARTH
13 12 11 10
5 Serial Number
6 SR7/SC7
7 SR6/SC6
8 SR5/SC5
To connect the signal to the terminal block, perform the following steps
while referring to Figure 2:
1. Remove the TBX-1329 terminal block cover by unscrewing the four
captive cover screws in the cover corners. These screws stay attached
to the cover without falling out.
before removing equipment covers or connecting or
4 5
9 8 7
9 SR4/SC4
10 SR3/SC3
11 SR2/SC2
Figure 1. TBX-1329 Parts Locator Diagram
7
2
1
6
12 SR1/SC1
13 SR0/SC0
14 SCXI Module-Type Rows
TBX-1329 Installation Guide