Connecting The Signals - National Instruments CB-37F-HVD Installation Manual

❑
❑

Connecting the Signals

To connect signals to the CB-37F-HVD terminal block, refer to Figure 2
while completing the following steps.
Note Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting or disconnecting any signal wires.
© National Instruments Corporation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Documentation (available at
– Read Me First: Safety and Radio-Frequency Interference
– DAQ Getting Started Guide
– Documentation for your DAQ device
– 37-Pin High-Voltage Accessory Safety Kit Installation Guide
(supplied with the 37-Pin High-Voltage Accessory Safety Kit)
Tools
– 1/8 in. flathead screwdriver
– Wire insulation stripper
3
)
ni.com/manuals
NI CB-37F-HVD Installation Guide