Connecting The Signals - National Instruments Terminal Block NI TB-2706 Installation Manual

Connecting the Signals

Refer to Figure 1 as you complete the following steps to connect signals to your terminal block.
1 Top Cover Screw
2 Cover
3 Chassis Ground Lug
4 Strain-Relief Screw
5 Terminal Block Mounting Screw
1. Remove the terminal block cover by unscrewing the top cover screw using the 0.10 in. slotted
screwdriver.
Note Your kit contains a pinout label for M Series devices only, shown in Figure 2. This label,
adhered to the inside of the cover, is a pin number-to-signal name reference. For PXI-6143 pin
connections, refer to Figure 3 or the S Series User Manual.
© National Instruments Corporation
13
12
11
10
9
6 Strain-Relief Bar
7 Signal Wire
8 Strain-Relief Opening
9 Base
Figure 1. TB-2706 Parts Locator Diagram
1
3
7
8
10 Screw Terminals
11 Base Tab
12 Connection to PXI/PXIe Module
13 Cover Indentation
3
2
4
5
6
NI TB-2706 Installation Guide