Keystone Correction – Keystone; Camera - Toshiba TLP680U Owner's Manual

Adjustments
Keystone correction
– Keystone
Preparation
• Display the image as explained in "Picture
Projection".
21
• Set the POINTER/PJ selector to "PJ".
SELECT/ADJUST
ON/STANDBY MENU ENTER
AUTO SET ON/STANDBY
KEYSTONE
MARKER LASER
POINTER
1,7
PJ
L-CLICK R-CLICK
MENU ENTER
RGB VIDEO CAMERA
RESIZE RESET FREEZE
1
Press MENU to display the
menu.
2
Press
Ke y s t o n e
ON
3
INPUT
Press
LAMP
TEMP
4
Press ENTER.
The keystone distortion is corrected
automatically. For further correction,
KEYSTONE
follow the below steps.
2,3,5,6
5
Press .
4
6
Press
RESET distortion.
(–): To reduce the upper width.
(+): To reduce the lower width.
7
Press MENU.
The menu disappears.
or to select .
A u t o s e t
A d j u s t – +
to select "Auto set".
or to correct the
CONTENTS
Notes
• Pressing KEYSTONE on the remote control
can also correct the keystone distortion
22
automatically.
• These adjustments are stored until you turn
the power off.
• Pressing RESET will return the adjustment or
setting currently selected to default.
• Pictures may be slightly deteriorated by the
keystone correction.
0 degrees setting for the automatic
keystone correction
Depending on the operating condition such as
vibration, the distortion may be beyond the
automatic keystone correction. The horizontal
condition setting (0 degrees setting) may be
disordered. In such a case, perform the
following 0 degrees setting to correct the
distortion.
1) Place the projector on a level surface.
2) On the menu, select "Auto set" in
"Keystone".
3) Press RESET.
Notes
• Do not make the 0 degrees setting on an
inclined or unstable surface or in a shaky
place as it may not be performed properly.
• To store this setting even if the power is
turned off, follow the procedure of "Saving
data".
34
30