Signalling Devices - CAME BXV Series Installation Manual

Signalling devices

1
Command and control devices
1 - Antenna with RG58 cable
2 - STOP button (NC contact)
It stops the gate and excludes the automatic closing. Use a control device to resume movement.
If the contact is not used, it must be deactivated during the programming.
3 - Control device
OPEN ONLY or PARTIAL OPENING function
It allows complete or partial opening of the gate.
4 - Control device
OPEN-CLOSE (step-step) or OPEN-STOP-CLOSE-STOP (sequential) function
5 - Card reader
6 - Transponder selector switch
7 - Keypad selector
1
10 11 E 5
2
10 TS 2 CX CY
1 2 3P 7
24 0
2 3 4
W
1 - Additional light
Increases the lighting in the manoeuvring area.
2 - Additional flashing light
It flashes during the operator opening and closing phases.
3 - Operator status warning light
It warns of the operator status.
3
+ E -
FC FA F
10 11 E 5 M N
5 6
Maximum contact capacity 10 - 5 24 V AC/DC - 3W
Maximum contact capacity 10 - E 24 V AC/DC - 25
S1 GND
A B A B GND
7