Listening To Stored Stations; Storing Stations; Scanning Receivable Stations; Starting Scan - Blaupunkt KIEL CD36 Operating Instructions Manual

➮
Press the or
peatedly until "SENS" and the cur-
rently set value appear in the dis-
play.
"SENS HI6" means that the tuner is set
to the highest sensitivity setting. "SENS
LO1" means it is set to the lowest sen-
sitivity setting.
➮
Set the desired sensitivity using
buttons 7.
the
When you have finished adjusting the
setting,
➮
press the MENU button 8.
Note:
You can set different sensitivity
G
levels for FM and MW or LW (AM)
(MW/LW only on the Malaga
CD36).
➮
Select the memory bank that you
want (FM1, FM2, FMT) or one of
the wavebands (MW or LW) (MW/
LW only on the Malaga CD36).
➮
Tune into the station that you
want.
➮
Press and hold down one of the
station buttons 1 - 6 : for longer
than two seconds to assign the
station to that button.
You can automatically store the six sta-
tions providing the best reception in the
region (only FM). The stations are
stored in the FMT memory bank.
button 7 re-
Note:
Any stations previously stored in
G
this memory bank are deleted in
the process.
➮
Press and hold down the BND•TS
button ; for longer than two sec-
onds.
The storing procedure begins. "FM
TSTORE" appears in the display. After
the process has completed, the radio
will play the station that is stored in
memory location 1 of the FMT memo-
ry bank.
➮
Select the memory bank or wave-
band.
➮
Press the station button 1 - 6 :
that corresponds to the station
that you want to listen to.
You can use the scan function to listen
to all the receivable stations briefly. You
can set the scanning time in the menu
to between 5 and 30 seconds (in steps
of 5 seconds).
➮
Press and hold down the MENU
button 8 for longer than two sec-
onds.
Scanning begins. "SCAN" appears
briefly in the display followed by a flash-
ing display of the current station name
or frequency.
33