User's Manual
Printer error
Pointing device
If you are using a PS/2 mouse, also refer to Chapter 8,
your mouse documentation.
AccuPoint II
Problem
On-screen pointer
does not respond to
AccuPoint II operation
PS/2 mouse
Problem
On-screen pointer
does not respond to
PS/2 mouse operation
9-16
Make sure your software is configured to recog-
nize the printer. Check your printer and software
documentation.
Check your printer documentation.
If problems persist, contact your dealer.
Procedure
If a PS/2 or serial mouse is connected, check
the HW Setup window. The Pointing Device
option should be set to Simultaneous to use
both the AccuPoint II and an external PS/2
mouse.
If problems persist, contact your dealer.
Procedure
Check that the PS/2 mouse cable's 6-pin
connector is firmly connected to the PS/2 mouse/
keyboard port.
You may have connected the mouse after turning
the computer on. Turn off the computer, make
sure the mouse is firmly connected and turn the
computer back on.
Optional
Devices, and to