Table of Contents
Advertisement
RS485/232 Port Configuration
•
Edit Protocol Selection: Menu selection 1 allows you to change
what serial protocol is running on the selected port. Note that not all
ports run the same protocols. Figure 20 shows how to change the
protocol selection from the current setting of Metasys N2 to Modbus
slave.
•
Edit Baudrate: Menu selection 2 allows you to change the baudrate
for the selected port. Note that the baudrate for some protocols is
determined by the specification, and these will therefore ignore this
setting.
•
Edit Parity: Menu selection 3 allows you to change the parity for the
selected port. Note that the parity for some protocols is determined by
the specification, and these will therefore ignore this setting.
•
Edit address: Menu selection 4 allows you to edit the network
address that the selected port will respond to. This setting is
applicable for slave protocols only.
•
Edit Timeout: Menu selection 5 allows you to edit the timeout time
for the selected port. Refer to section 11.2 for more information on
timeout processing.
Figure 20: Edit Port Configuration
40
Advertisement
Table of Contents
