Terminal Module Tm-P30X44-A0 (6Es7193-4Ckx0-0Aa0) - Siemens SIMATIC ET 200S Manual

Properties

1.5 Terminal module TM-P30x44-A0 (6ES7193-4CKx0-0AA0)

1.5 Terminal module TM-P30x44-A0 (6ES7193-4CKx0-0AA0)
Properties
● Terminal module for fail-safe PM-E F 24 VDC PROFIsafe power modules
● Infeed for a new potential group up to the next TM-P terminal module
● Available in two variants: screw terminal, spring terminal
● Wiring of the fail-safe digital outputs of the PM-E F 24 VDC PROFIsafe
● Interrupted AUX1 bus without electrical connection to the next potential group to the left
● Access to the AUX1 potential through terminals A4 and A8
Block diagram
Block diagram of the TM-P30S44-A0 and TM-P30C44-A0 terminal module
PM – EF
2
3
A
4
①
②
③
④
⑤
14
CAUTION
If high currents occur at DO 2 P and DO 2 M, you must wire terminals 11 and 15 (DO 2
P) and 12 and 16 (DO 2 M) in parallel. Otherwise, the temperature of the terminals
cannot be prevented from rising due to the current load.
1
2
9 1
3
6 1 1
0 4
3
1 1
7 1 5
A 1 1
8 2 6
4
5
Backplane bus
Infeed of the power buses to the electronic modules
Terminals with connection to the power module
Use of terminals A4 and A8 as protective conductor terminals or potential terminals of any
kind
Infeed of the AUX1 bus by means of terminals A4 and A8
Terminal modules
Manual, 04/2007, A5E01120034-01