Toshiba gigabeat MEG-F20 Owner's Manual page 146

Issue
The charge indica-
tor doesn't illumi-
nate, in charging
operation.
The charge indica-
tor turned off while
the AC adapter
was connected.
The PC does not
recognize the
gigabeat.
Reset
If the issue cannot be resolved after taking the above corrective actions, reset the
main unit by following the steps below:
1 Unplug the AC adapter from the main unit.
2 Turn "OFF" the BATTERY switch once. After about 5 second turn "ON"
again.
The date and time will be reset.
Other settings don't return to the initial state.
Execute "SETUP" - "SYSTEM" - "FACTORY DEFAULT SETTINGS" to return to the
initial setting in order to return to the initial setting.
Cause
The BATTERY switch
is set to "OFF".
The gigabeat is not
connected properly.
Outside the specified
operating-tempera-
ture range.
The charge is auto-
matically stopped to
limit the temperature
increase in the giga-
beat.
The gigabeat is not
properly connected to
the PC.
Solution
Set the BATTERY
switch to "ON".
Check the connection
between the AC
adapter/AC cable and
the main unit.
Charge within the oper-
ating-temperature
range.
This is a safety feature.
Keep the gigabeat in the
charging operation.
Charging will resume
after a while.
Check the connection
with the PC.
146
Refer
> p. 24
> p. 24
> p. 151
> p. 26
> p. 29