Trane BACnet BCI-R Integration Manual page 8

Configuring the BCI-R
To connect to Tracer TU:
1. Connect the USB cable directly from the laptop to the BCI-R, or to an equipment control panel
Important: If using a PC with multiple USB ports, connect by using the same process outlined
2. Click either the Tracer TU desktop icon or the Tracer TU program item in the Tracer TU group
Figure 4. Connect dialog box
3. Select the Direct Connection (USB cable) radio button if it is not already selected.
4. Click the Connect button and the Unit Summary page will appear after successful connection.
To configure the BCI-R controller:
1. Select the Controller Settings Utility tab from the vertical tab set located on the right side of the
2. Enter a meaningful name for the controller.
3. Click the Controller Units expanding box label to display its contents.
4. Select the preferred units of measure for data communicated across the BACnet link.
5. Click the Protocol expanding box heading to display its contents.
6. Select the preferred Baud Rate in the drop-down list box.
7. If a software Device ID is required, check the Use Software Device ID box and enter a BACnet
8. Click Save.
8
USB port connected to the controller.
below for the same piece of equipment. This is normal operation. Observe existing
USB standards for cable length. (For more information go to informational Web
sites, such as http://www.USB.org.)
on the Start menu.
The Tracer TU splash screen appears briefly followed by the Connect dialog box.
TU window.
Note: The content of this screen is based on the type of controller that is connected and the
system protocol used to communicate with the controller.
Device ID.
BAS-SVP09B-EN