Faults And What To Do About Them - Siemens XQG62-WS12K2601W Instruction Manual And Installation Instructions

Faults and what to do about them

en
Faults and what to do about
them
Faults
Water is running out.
Water not flowing in.
Detergent not washed in.
Washing machine door
cannot be opened.
Programme does not
start.
Additional function could
not activate for selected
programme.
Water is not drained.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Spin cycle activated sev-
eral times.
Dispenser not completely
rinsed out.
Stain formation in the
washing machine.
Foam is coming out of the
detergent drawer.
24
Cause/Remedy
Fit/refit drainage hose correctly.
■
Tighten screw–fitting on the supply hose.
■
Start/Reload not selected?
■
Tap not open?
■
Filter blocked? Clean filter.
■
Supply hose kinked or jammed?
■
There is water in the drum?
Safety function active. Stop programme?
■
- - - - (Rinse stop= without final spin) selected?
■
Can be opened via emergency release only. ~ Page 23
■
Childproof lock activated? Deactivate childproof lock. ~ Page 13
■
Start/Reload or 5 (Finish in) selected?
■
Washing machine door closed?
■
If the additional function is selectable?
■
- - - -(Rinse stop= without final spin) selected?
■
Clean the drain pump. ~ Page 21
■
Clean outlet pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Wash small and large items of washing together.
■
(Less iron) selected?
■
Too low speed selected?
■
Not a fault – unbalanced load detection system adjusts imbalance.
Remove the insert. Clean detergent drawer and re-insert.~ Page 20
■
Run Drum clean 90 °C programme without washing.
Use standard detergent.
Too much detergent used?
Mix 1 tablespoon of fabric conditioner with ½ litre of water and pour into
dispenser II in the detergent drawer.
Reduce detergent dosage for the next wash cycle.