Toshiba QOSMIO F60 User Manual page 155

LAN
Wake-up on LAN
This feature lets the computer's power be turned on from shudown when it
receives a wake-up packet (Magic packet) from the LAN.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■
The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■
Regarding Wake-up on LAN from sleep or hibernation, you must check
the "Allow the device to wake the computer" check box within the LAN
Device properties. (This feature does not effect the Wake-up on LAN
from sleep or hibernation.)
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6,
data with power
Enabled
Disabled
Built-in LAN
This feature enables or disables the Built-in LAN.
Enabled
Disabled
SATA
eSATA
This feature allows you to set conditions of eSATA.
Enabled
Disabled
User's Manual
off.
Enables Wake-up on LAN.
Disables Wake-up on LAN (Default).
Enables Built-in LAN functions (Default).
Disables Built-in LAN functions.
Enables the eSATA port (Default).
Disables the eSATA port in order to save power.
HW Setup
Retaining
7-5