Table of Contents
Advertisement
4
Installation
The machine is set up, installed, and handed over ready
for use by customer service. Due to the associated
hazards, modifications to the installation or setup must
be carried out by customer service only.
Make sure that the following prerequisites are met
before you use the machine.
4�1
Water connection
The water connection must be easy to shut off at any
time during operation (shut-off valve). The equipment
is to be installed to comply with the applicable federal,
state, or local plumbing codes and regulations, e.g.,
4
EN 61770.
The limit values for water pressure and carbonate
hardness as given in the technical data must be observed.
Only use a new hose set. Old or used hose sets are not
permitted to be re-connected.
The water drain must only be installed via a fixed
connection with odor trap that is protected against
backwater and backflow. This prevents contamination in
the machine due to backflowing waste water.
4�2
Electrical connection
The supply voltage must match the specifications on the
nameplate.
The supply line must be fuse-protected at the site with
3 x 16 A. The connection must also be protected using a
residual current circuit breaker (RCCB) (max. 30 mA).
If the equipment is connected permanently, a switch for
an all-pole disconnection with at least three millimeters
of contact clearance must be provided by the customer.
For connection via a mains plug, the socket must be
easily accessible during operation so that the plug can be
disconnected in the event of a fault.
Due to the high power, a separately fused circuit is
required for the machine.
Installation
8
4�3
Installation location
The machine is only to be installed and used in enclosed,
dry areas; it must not be operated outdoors.
The effects of humidity and temperature may adversely
affect the function and safety of the equipment.
The machine must always be installed and stored in
frost-free locations.
The installation area must provide sufficient distances
from walls and objects due to the heat generated and for
operation of the machine.
Distances
To the back
To the top
In self-service operation, the machine and all accessory
units must be installed in such a way that they can be
permanently supervised by trained personnel.
The machine must be positioned level and free of vibra-
tions. Adjustable feet are provided so that the unit can
be leveled out on slightly uneven surfaces.
4�4
Product material
The ground coffee must be suitable for use in commer-
cial coffee machines. Only use dry and loose material
without clumps.
At least 5 cm
At least 20 cm
32743 • 20190801
Advertisement
Table of Contents
