Safety Instructions; Installation; Prerequisites; A) Prerequisites For Water Connection - Melitta CT8 Operating Instructions Manual

4. Safety Instructions

These safety instructions refer only to the product
itself. Apart from that there myay be legal obligations
of the operatir, e.g. concerning food hygiene as well
as health and safety.
m
In the beverage dispensing area there is danger
of scalding when hot liquids are dispensed. This
is the case ...
during heating up after switching on,
when beverages are dispensed,
during automatic cleaning.
m
Danger of crushing if somebody reaches into
the provision container while the machine is run-
ning.
m
There may be danger to life caused by electri-
cal shock as well as risk of injury due to hot or
moving parts when housing parts or covers are
opened.
Make sure that no person reaches into the ma-
chine while it is still switched on.
Never open any housing parts or covers unless
instructed to do so. There are no operating ele-
ments inside the machine.
m
Protect the machine from humidity! There
may be danger to life through electrical shock if
water reaches machine parts other than those
specifically intended for contact with water. You
should in particular ...
never operate the machine outdoors,
never hose down the machine with water,
never hose down the installation area with wa-
ter, e.g. using a hose or high-pressure cleaner.
m
Do not continue using the machine if damag-
es are visible or apparent malfunctions oc-
cur. Important safety functions may in this case
be disturbed. Have them first inspected and, if
necessary, repaired by the customer service,
e.g. ...
if the housing is damaged or covers do not
close properly,
if power cord or power plug are damaged or if
the fuse for the circuit of the machine trips re-
peatedly,
if water escapes from the machine,
if error messages appear in the display or if the
machine does not function normally,
if unusual odours can be detected or heat de-
velopment on the housing is apparent (the hous-
ing is normally only warm to the touch during op-
eration).
In all of these cases, pull the plug out of the
socket and turn off the water. Then notify custo-
mer service.
m
Comply with all intervals for cleaning, inspec-
tion and maintenance, as specified in the instruc-
tion manual. Otherwise, the safety, functional re-
liability and durability may be impaired.

5. Installation

Customer service will set up, install and hand-over
the device ready for operation. You should leave
changes on the installation or setup only to customer
service because of the associated hazards.

5.1 Prerequisites

Make sure that the following prerequisites are met
before you use the machine:
a) Prerequisites for water connection
The water connection must be easy to turn off at any
time during operation (stop valve) and must meet the
requirements of EN 61770
The limiting values for water pressure and carbonate
hardness, as specified in the technical data, must
complied with. The water supply must generally be
equipped with a fine filter.
Only use the new hose kit! Old, previously used
hose sets must not be connected anew.
The waste water drain must be installed as a fixed
connection with odour trap, protected against back-
water and backflow, in order to protect the machine
against contamination from back flowing waste water.

b) Prerequisites for electrical connection

The supply voltage must match the specifications
on the type plate.
The supply line must be fuse-protected by the cus-
tomer using a fault current circuit breaker (FCCB)
(max. 30 mA).
When connected via a power plug, the outlet must
be easily accessible during operation to be able to
pull the plug in case of malfunction.
c) Requirements on the personnel
Adjustments, cleaning and preparations on the
machine must only be performed by the installer or
by persons instructed by the manufacturer.
4