Chicago Electric 91220 Assembly And Operating Instructions Manual page 12

8. NOTE: The Mini Arc Welder is equipped with an automatic "Hot Start". This
feature momentarily surges the current output, which makes starting the elec-
trode easier. Should the electrode stick to the workpiece, usually a quick twist of
the Electrode Holder (7) will break the electrode free. If the electrode is not
broken loose, shut down the Mini Arc Welder and physically remove the
electrode from the Electrode Holder and workpiece. CAUTION! The electrode
and metal are hot.
ELECTRODE
(NOT INCLUDED)
WORKPIECE
9. When the job is completed, turn the Power Switch (5) to its "OFF" position,
and unplug the Power Cord (9) from its electrical outlet. Then, remove the
Ground Clamp (8) from the workpiece or metal table. (See Figure D.)
SKU 91220
POWER
CORD/PLUG
(9)
ELECTRODE
HOLDER
(7)
GROUND
CLAMP
(8)
POWER
SWITCH
(5)
PAGE 12
FIGURE D