Table of Contents
Advertisement
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 15.
1.
WARNING! Prior to performing any assembly procedures, make sure
the Power Cord of the Mini Arc Welder is unplugged from its electrical
outlet.
2.
Before use, ground the Body Grounding Connector (13) directly to an earth pipe
or grounding rod with a separate cable of appropriate size (not included).
IMPORTANT: Only a qualified, certified electrician should perform this
procedure.
3.
Install an electrode (not included) into the Electrode Holder (7) by squeezing the
Holder while positioning the electrode at the desired angle.
(See Figure D, next page.)
Connect the Ground Clamp (8) to the workpiece or to a metal welding table
4.
where the workpiece will be placed. (See Figure D.)
5.
Plug the Power Cord (9) into the nearest 110 volt, grounded, electrical outlet.
6.
Hold the Electrode Holder (7) away from all objects. Then, turn the Power Switch
(5) to its "ON" position. (See Figure D.)
7.
To begin welding, position the electrode at about a 60 degree angle and touch
the tip of it to the workpiece. Once the arc is stable, move the electrode along
the workpiece and down as the welding process consumes the electrode. Re-
place the electrode as needed to complete the job. (See Figure D.)
SKU 91220
PAGE 11
Advertisement
Table of Contents
