Table of Contents
Advertisement
B-2
1
2
3
WELDING CONTROLS
1. OUTPUT CONTROL:
vides continuous control of the welding current.
2. THERMAL SHUTDOWN INDICATOR
LIGHT: I
ndicates that the welding output is shut off
because of blocked airflow or the welding current
exceeded the rating of the machine
3. WELD OUTPUT TERMINALS WITH
FLANGE NUT:
Provides a connection point for the
electrode and work cables.
4. GROUND STUD:
Provides a connection point
for connecting the machine case to earth ground for
the safest grounding procedure.
ENGINE CONTROLS
5. RUN/STOP SWITCH:
the engine prior to starting. STOP position stops the
OPERATION
The OUTPUT dial pro-
.
RUN position energizes
RANGER 200
engine. The oil pressure interlock switch prevents
battery drain if the switch is left in the RUN position
and the engine is not operating.
6. CHOKE:
When pulled out, it closes the choke
valve on the engine carburetor for quick starting.
7. START:
PUSH BUTTON
motor to crank the engine.
8. IDLER:
SWITCH- Has two positions as follows:
1)
In the HIGH position, the engine runs at the high
idle speed controlled by the engine governor.
2)
In the AUTO position, the idler operates as fol-
lows:
A. When switched from HIGH to AUTO or after start-
ing the engine, the engine will operate at full speed
for approximately 12 seconds and then go to low
idle speed.
B-2
10
9
8
7
6
5
4
-
Energizes the starter
Advertisement
Table of Contents
