Troubleshooting - Saeco 10000006 Operating Instructions Manual

ENGLISH
Problem
The machine does not turn on The machine is not connected to the
The pump is very noisy
The coffee is too cold
T h e m i l k d o e s n o t f r o t h
properly
The coffee flows out too fast
and no creamy froth forms on
the surface
No coffee flows out or it just
drips out slowly
Coffee leaks outside the rim
Should any problems occur that are not included in the above table or cannot be re-
solved using the remedies suggested contact an authorised service centre.
• 28 •
Possible causes
power supply
Water level in tank too low
The temperature ready light (5) was off
when you pressed the switch (4)
Filter holder not inserted for pre-
heating (section 5).
Wrong kind of milk
Not enough coffee in the filter holder Add some coffee
Coffee ground too coarsely
Stale or unsuitable coffee.
Water level in tank too low
Coffee ground too finely
Coffee compressed too firmly in the
filter
Too much coffee in the filter
"Hot water/steam" knob (7) open.
Excessive buildup of scale
Filter in filter holder clogged
Filter holder not properly fit into brew
unit
Upper rim of filter holder dirty
Boiler gasket dirty or worn
Too much coffee in the filter holder

Troubleshooting

Remedy
Connect the machine to the power
supply
Add water
(section 4.4)
Wait until the light goes on
Pre-heat the filter holder
Check the fat content
(section 5)
Use a different blend
(section 6)
Use a different blend
(section 6).
Add water
(section 4.4)
Use a different blend
(section 6)
Loosen the ground coffee
Reduce the amount of coffee in
the filter holder
Turn the knob (7) clockwise to
close
Descale the machine
(section 10)
Clean the filter (section 9)
Fit the filter holder properly in
place (section 5)
Clean the filter holder rim
Clean or replace gasket
Reduce the amount of coffee.
Use the measure for the right
amount.