Operating Homelink; Before Programming - Lexus RC F Owner's Manual

278 5-5. Using the other interior features
Reprogramming a single
■
HomeLink
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1 With one hand, press and hold the
desired HomeLink
2 When the HomeLink
starts flashing (orange), continue to
hold the HomeLink
perform "Programming
HomeLink
onds for the HomeLink
to start flashing).

Before programming

■
Install a new battery in the transmitter.
●
The battery side of the transmitter must
●
be pointed away from the HomeLink

Operating HomeLink

Press the appropriate HomeLink
button. The HomeLink
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
RC F̲OM̲(GE)̲1903
RC F_OM_General_OM24838E
®
button
®
button.
®
indicator
®
button and
®
" 1 (it takes 20 sec-
®
indicator
®
.
®
®
®
indicator light
Opening
A
Closing
B
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
Color
Currently open-
Orange (flashing)
ing/closing
Opening/closing has
Green
completed
Feedback signals
Red (flashing)
cannot be received
The indicators can operate within
approximately 250 m (820 ft.) of the
garage door. However, if there are
obstructions between the garage door
and the vehicle, such as houses and
trees, feedback signals from the
garage door may not be received.
To recall the previous door operation
status, press and release either
®
HomeLink buttons
or and
neously. The last recorded status will
be displayed for 3 seconds.
Status
and
simulta-