Circuit Priming - Saeco 10003176 Operating Instructions Manual

INSTALLATION
Always use only fresh, non-sparkling water
to fi ll the tank (7). Hot water or any other
liquid may damage the tank and/or the machine.
Do not turn on the machine without water: make
sure there is enough water in the tank.
• (Fig.24) - Remove the cover (2) and add the coffee
beans.
Always add only coffee beans in the coffee
bean hopper (1). Ground coffee, instant
coffee or any other object may damage the
machine.
• Replace the cover (2) on the coffee bean hopper (1).
• Insert the plug into a suitable socket.

4.3 Circuit Priming

In the beginning, after dispensing steam or when the
water tank is empty, the machine's water circuit must
be primed.
• The power button (5) is switched to -0-. Press but-
ton (5) to turn on the machine. The light (23) on the
control panel will turn on.
• (Fig.26) - Place a container beneath the steam
wand (Pannarello)(12) to prime the circuit. Turn the
knob (14) counter-clockwise and wait until water
fl ows steadily out of the steam wand (Pannarello).
Turn the knob (14) clockwise to stop water dispens-
ing.
• The circuit is now primed.
4.4 Using the machine for the
fi rst time or after a period of
inactivity
This simple operation ensures optimum brewing and
must be performed:
- At fi rst start-up;
- When the machine remains inactive for a long time
(more than 2 weeks).
Dispensed water must be emptied into an
adequate drain. It is not suitable for food
use. If the container fi lls up, stop dispensing water
during the cycle and empty it before resuming
the operation.
1 (Fig.25) - Make sure that the water tank (7) is fi lled
with drinking water; otherwise, empty the tank and
replace with fresh water.
2 Place a container beneath the steam wand
(Pannarello) (12) and turn the knob (14) counter-
clockwise.
3 After 30 seconds (or when the container is full)
stop dispensing water by turning the knob (14)
clockwise.
4 Wait about 60 seconds. Repeat the operations from
step 2 until emptying out the tank.
5 (Fig.25) - Once run out of water, fi ll the tank again
(7) and carry out a new cycle from step (2) as previ-
ously mentioned.
6 Once emptied the tank for the second time, fi ll it
again with water; the machine is now ready for
use.
Note: if required, prime the circuit.
• To brew coffee, dispense hot water or steam, and
for a proper use of the machine, carefully follow the
instructions provided.
9