Installation/Connection; Keycard Theft-Protection System; Putting The Unit Into Operation; Removing The Keycard - Blaupunkt CASABLANCA RCM 85 Operating Instructions Manual

Installation/Connection

If you would like to install this equipment
yourself or add any new components, please
read the enclosed installation and connec-
tion instructions carefully.
Do not connect the loudspeaker outputs to
ground!
Use only the accessory and replacement
parts approved by Blaupunkt.
24

KeyCard theft-protection system

This car radio is supplied with one KeyCard
as standard.
However, the unit can also be operated with
a second card.
If you have lost or damaged your KeyCard,
you can buy a new one from your specialised
dealer.
When using two KeyCards, you can indivi-
dually store the following functions:
Bass, treble, balance and fader settings,
assignments of preset buttons, Loudness,
TA (traffic announcement volume), BEEP
volume.
In addition to this, the settings activated be-
fore switching the radio off, such as the
waveband, station, TA priority, Loudness,
AF, REG ON/OFF and seek tuning sensitivi-
ty, will also remained stored.
This ensures that the basic settings you have
programmed will automatically be activated
as soon as you have inserted your KeyCard.

Putting the unit into operation

• Turn on the set and introduce the Key-
Card into the slot with the contact area
showing up (KeyCard tongue pulled
out).
The car radio is now ready for operation.
If a wrong KeyCard is inserted, then "CARD
ERR" will appear in the display. In this case
please do not go on operating the set.
After approximately 10 seconds, the display
will show "TURN OFF". Now turn off the set.
When inserting a card of a different kind (like
for example a phone or credit card), the
display will show "WRONG KC" for approxi-
mately 2 seconds.
Remove the wrong card and turn off the set.
Do not make further adjustments until you
have a correct KeyCard available.

Removing the KeyCard

Never pull out the KeyCard directly.
• First press the KeyCard in.
This releases the card and puts it in the
proper position for being removed.
• Now you can pull it out.
"Defining" a second KeyCard/
Replacing a KeyCard
While operating the unit with the first Key-
Card, you can "define" a second one to be
also used with the set:
• Insert the first KeyCard and turn on the
set.
• Press the DSC button and select
"LEARN KC" with / .
The display will switch to "CHANGE".