Troubleshooting - Yamaha Fino Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Turn signal light bulb
1. Open the seat. (See page 4-9 for
seat opening and closing proce-
dures.)
2. Remove panel C. (See page 7-7
for panel removing and installing
procedures.)
3. Remove the turn signal light bulb
socket by turning it counterclock-
wise.
7
ZAUU0101
1. Rear turn signal light bulb socket (
4. Remove the burnt-out bulb from
the socket by pulling it out.
ZAUU0102
1. Rear turn signal light bulb (
5. Insert a new bulb into the socket.
NOTICE
_
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
_
6. Install the socket into its original
position.
✕
2)
7. Install the panel, and then securely
close the seat.

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting chart
✕
2)
represents a quick and easy procedure
for checking these vital systems your-
ECAU0080
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
7-31
EAU25851