Table of Contents
Advertisement
&
Programming with 'SHOWVIEW'
All the information required for programming is encoded in the SHOWVIEW-code.
1
Switch on the TV set.
TIMER k
2
Press the
button on the remote control.
3
Please enter the SHOWVIEW-code (up to 9 digits) printed in your TV guide next to the start
time of a TV programme.
If you make a mistake, clear with the
4
If you want to programme at daily or weekly intervals, press the
LY' (daily intervals) or 'W-WEEKLY' (weekly intervals) appears in the display. The 'daily
intervals' function can only be used for recordings to be made from Mondays to Fridays
inclusive.
5
Confirm the entries with the
OK
button. The resultant data appears on the TV screen.
Note: If you use SHOWVIEW for the first time for this TV channel, the 'SELECT PROG' line
appears when you confirm the SHOWVIEW code. Select and confirm the programme number
for this particular TV programme.
* Switch 'VPS' (V/P) on or off with the
* If you wish to set a later end time for a recording, press the
P q
each press of the
button you add 15 minutes to the time.
* If e.g.: '20:00' appears in the display, please set the clock.
6
Finally, press the
OK
button. Programming is now complete.
The data has been stored in a TIMER block.
7
Make sure that a cassette without erase protection has been loaded. Switch to standby with
STANDBY m
the
button.
A programmed recording will function only when the video recorder is switched to standby
STANDBY m
with the
button.
CLEAR (CL)
button.
SELECT
button until 'D-DAI-
SELECT
button.
P q
button at step
5
How to programme a recording manually
1
Switch on the TV set. Press the
2
Select a free TIMER block. Press the
TIMER k
3
With the
'PROG' (programme number), 'START' (start time) and 'END' (end time).
You can enter or alter data.
You can switch 'VPS' (V/P) on and off at step 'START' with the
You can select between 'D' (daily intervals) or 'W' (weekly intervals) at step 'DATE' with the
SELECT
button.
. With
4
Finally, press the
5
Make sure that a cassette without erase protection has been loaded. Switch to standby with
STANDBY m
the
button.
A programmed recording will function only when the video recorder is switched to standby
STANDBY m
with the
Note:
* Clear a TIMER-block: At step
CLEAR (CL)
button.
* If e.g.: '20:00' appears in the display, the clock must be set.
TIMER k
button twice.
TIMER k
button.
DATE PROG START V/P END
01
01
20:00
21:30
------------------------
gTIMER CLEAR
gCL
NEXT
-/+
0-9
D/WgSELECT
OK
C
D
the
or the
button you can select between the entries 'DATE' (date),
OK
button. Programming is now complete.
button.
1
select the TIMER block you want to clear. Press the
SELECT
button.
Advertisement
Table of Contents
