Adjusting Height Of Embroidery Foot P - Janome MC350E Service Manual

MC350E

Adjusting Height of Embroidery Foot P

Attach the Foot (P), and the space between the needle plate and the bottom surface of the
Foot (P) should be 1.0 to 1.6 mm, when the needle bar is at its lowest position.
D
E
F
C
B
A
1. Remove the rear cover unit.
(See page 7)
2. Lower the Needle
3. Insert the 1.2 mm Feeler gauge
the Embroidery Foot (P)
4. While pressing the Presser bar actuator
against the upper shaft cam, loosen the Screw
and push it down in the direction of arrow, then
tighten Screw
F
5. Reattach the rear cover unit.
A
Needle
B
1.2 mm
C
Embroidery front (P)
D
Needle plate
E Presser bar actuator
F
Screw
18
and lower the presser foot lifter.
A
B between
and the Needle plate
C
again.
.
D
E
down