32 Rerecording (Tape Duplication)
The instructions on this page show you how to copy tapes. The illustration uses two VR602BMG VCRs.
Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow steps 1-7.
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
VCR 1
Playing VCR
ANT
AUDIO
IN
L
IN
OUT
R
VIDEO
OUT
CH3 CH4
OUT
IN
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
Audio and Video cables are not supplied.
1
Make the connections shown above.
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. The
VCR must be in VCR position. (The VCR Light will appear on the dis-
play panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press the Number
buttons 0, 0, 1 or 0, 0, 2. (See Helpful Hints at right.)
6
Press the SPEED button to select SP or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
VCR 2 - Recording VCR
• If you use the AUDIO and VIDEO IN
Jacks on the back of VCR 2, press
Number buttons 0, 0, 1 at step 5.
AV REAR will appear on the screen.
• If you use the AUDIO and VIDEO In
Jacks on the front of VCR 2, press
Number buttons 0, 0, 2 at step 5.
AV FRONT will appear on the
screen.
• Unauthorized recording of copyright-
ed television programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws.
• If a program has copyright protec-
tion, it may not record clearly.
• These instructions show you how to
copy tapes using two VCRs like
yours. Different VCRs may operate
differently.
• The VCR in the figure above is the
VR602BMG. If you have the
VR402BMG, use a single-plug audio
cable to connect the AUDIO OUT
jack on VCR 1 to the AUDIO IN jack
on VCR 2.
AUDIO
ANT
L
IN
OUT
IN
R
VIDEO
OUT
CH3 CH4
OUT
IN
3. RF coaxial cable
from the OUT jack of
VCR 2 to the TV's
ANTENNA IN Jack
Helpful Hints