Philips VR810BPH Owner's Manual page 54

54 Setting the Controller to Operate a DBS (cont'd)
6
Press the PLAY 8 or STOP 9 button to set the two-digit
code for your DBS (see list below), then press the
OK/STATUS button.
SELECT CODE NUMBER
OF YOUR DBS RECEIVER
40
DID DBS RECEIVER
CHANGE TO CHANNEL 205?
A YES
NO
SELECT: 89
CONFIRM:OK
END: MENU
DBS CODES
MAGNAVOX DBS........................................................42, 43
RCA DBS ................................................................................40
SONY DBS.............................................................................41
7
Wait for a few seconds.
• If the DBS changes to channel 205, go to step 8.
• If the DBS doesn't change to channel 205, press the PLAY 8 or
STOP 9 button to select NO, then press the OK/STATUS but-
ton. Repeat steps 6-7, using a different code for your brand (if
available).
• If the DBS does not respond to any of the codes, press the
MENU button to remove the menu. DBS RECEIVER CON-
TROL IS OFF will appear on the screen briefly.
8
Press the PLAY 8 or STOP 9 button to select YES, then
press the OK/STATUS button. "DBS RECEIVER CONTROL
IS ON" will appear for five seconds. "AS A RESULT AUTO
CLOCK WILL BE TURNED OFF" may appear on the screen also.
7 Wait for a few seconds.
SAT/
CBL/DBS
VCR/TV POWER
QUICK PROGRAMMING
+
1 2
— + *
START STOP
-
4 5
GHI
VPS/PDC DAILY
7 8
PQRS
SPEED DBS/SAT
ALT 0
STILL/SLOW
-
..........
6-8
REW
PLAY
STOP
VOL
OK/STATUS
MENU
TIMER
TURBO AUDIO/
TIMER MUTE
JOG/SHTL
REV
Helpful Hint
• If your DBS does not respond to the
code at step 7, the Controller will
not change channels at the DBS
during a timer recording. In this
case, you must select the channel to
be recorded at the DBS before a
timer recording begins. Enter the
DBS output channel at step 3 on
page 40. Leave the DBS on for the
timer recording. Details are on page
eight.
TV VCR
SMARTPICTURE
+
3
ABC DEF
DATE
-
6
JKL MNO
WEEKLY
9
TUV WXYZ
CLEAR
+
..........
FF
CH
SKIP TAPE
SEARCH MANAGER
/OTR
REC REC
FWD