Pioneer TVM-PW910T Instruction Manual page 4

Safety precautions
Mandatory
When changing the installation, wiring or the
location, always consult the dealer for safety.
・ To perform the installation and wiring and
removing them require special techniques and
experience. Installing, wiring and removing
incorrectly may cause serious damage to the
vehicle.
Before working, always remove the ⊖terminal
of the battery
・ Short-circuiting of the ⊕、⊖ poles may cause
electric shock, or injury.
Before working, check the pipes, tank and
electrical wiring location.
・ When opening holes on the body for
installation, pay attention not to cause
interference, contact to the pipes, tanks or the
electrical wiring. Provide waste collection
system at the work area and prevent water
infiltration.
Always use
and secure them properly
・ Using components that have not been provided
may damage the internal parts; moreover, they
may not be secured properly, thus causing
obstruction to linked operation and resulting in
accident or damage.
Connect and install based on the manual
・ Connecting and installing without following the
manual may cause fire or damage.
Insulate with tape if the cord has no cover
・ Short circuit may cause fire, electric shock, or
damage.
Wire in such a way that the cord is not squeezed
inside the movable part - the car body, bolt, sheet
rail
・ Broken wire or short circuit may cause fire,
electric shock, or damage.
4
Warning
the components provided,
(Continued)
Mandatory
Secure the cord so that it does not obstruct driving
・ If it is caught by the steering wheel, selection bar
or hand brake, accident may happen.
Once installation and wiring is complete, check if
the electrical instruments are working properly
・ Using under improper operational condition may
cause fire, electric shock, or traffic accident.
Keep the bolts and other small items away from
the reach of children
・ If swollen unintentionally, seek the help of a
doctor immediately.
Prohibited
Do not install under direct sunlight or directly
facing the hot air from heater
・ The internal temperature may rise, which can
cause fire or damage.
Do not install the device at an unstable location
・ It may cause the set to fall off.
Do not obstruct the ventilation outlet or heat
dissipation plate
・ Heat may accumulate internally, thus causing fire
or damage.
Do not cut the cord halfway
・ Some cords may have fuse attached, and cutting
the cord halfway may cause the protection circuit
to malfunction, which causes fire or damage.
Warning
Precaution