Pioneer TVM-PW910T Instruction Manual page 28

Installing the monitor (continued)
Adjusting the shaft guide
■Shaft guide position (example)
The width between the shaft guides should be 110mm~169mm for a car with shaft diameter less than
14mm.
■Removing the shaft
guide
Pull up the nut of the
shaft guide from the
rear of the fixture to
remove
Shaft guide
When installed (left)
Protrusion
28
The narrowest
（110mm）
■Adjust, install
Shaft guide (left)
Pull to adjust
Hook
When installed (right)
Insert the hook's
gap into the
protrusion of the
fixture, then lock
the claw properly
to install.
The widest
（169mm）
Or
Lock the hook
て
properly into
the fixture to
install.
[How to adjust]
Slide the right
shaft guide to
adjust.
Shaft guide (right)
Slide to the right/left of
the hole, then change the
position as required to
install.
Or
Cushion tape
(accessories)
If the shaft
diameter is
small, use the
accessories'
cushion tape.