Advertisement
Quick Links
Kit Number KAX-25114
This instruction sheet describes how to install the Apple upgrade kit for Cybex bike models 625C and
625R.
Tools Required
Phillips screwdriver
•
Utility knife
•
ESD (Electrostatic Discharge) grounding strap
•
Read and understand all instructions thoroughly before installing this kit.
Verify the kit contents shown.
1
3
4
5
6
7
Apple iPod, iPhone Upgrade Kit 625CR
2
8
10
9
11
Page 1 of 7
Installation Instructions
Description
1 iPod assembly,
AX-24137
2 Screw, 6-19 x 0.50",
HS-18320
3 Cable, iPod, 30 pin,
AW-23768
4 Cable, GFX to MCC,
AW-23300
5 Cable, Headphone
jack jumper,
AW-23298
6 PCA, Headphone jack
board, AD-23332
7 Decal, Headphone
jack, DE-23399
8 Screw, 4 x 3/8",
HS-20553
9 Gasket, HX-23441
10 Screw, #8-32 x 0.50",
HS-21672
11 Bracket, grounding,
FS-23440
www.cybexintl.com
Qty.
1
4
1
1
1
1
1
2
1
2
1
Advertisement
Related Manuals for CYBEX KAX-25114
Summary of Contents for CYBEX KAX-25114
- Page 1 Apple iPod, iPhone Upgrade Kit 625CR Installation Instructions Kit Number KAX-25114 This instruction sheet describes how to install the Apple upgrade kit for Cybex bike models 625C and 625R. Tools Required Phillips screwdriver • Utility knife • ESD (Electrostatic Discharge) grounding strap •...
- Page 2 Disconnect optional external power source Unplug the unit from the power outlet. WARNING: Shock and electrocution hazard Unplug unit and let sit 10 minutes before cleaning or performing maintenance • Electrical charge can remain in unit after unplugging • Keep water and liquids away from electrical parts •...
- Page 3 2. Unplug cables by pinching latch and make sure it releases connector. Pull connector out. DO NOT PULL CONNECTOR OUT BY THE WIRES! Latch Pull Straight Out From Connector Install headphone jack board 1. Remove the blank decal from the headphone jack cover using a utility knife. Description Blank decal Headphone jack cover...
- Page 4 3. Install the headphone jack decal to the headphone jack cover. Description Headphone jack decal Headphone jack cover 4. Plug the headphone jack cable into the headphone jack board. Description Headphone jack board Plug cable in here Install grounding bracket 1.
- Page 5 3. Install the grounding bracket, grounding tab, and 8-32 x 0.50” screws to the console as shown using a Phillips screwdriver. Install iPod board 1. Remove the screw securing the clamp as shown using a Phillips screwdriver. Description Console front Clamp Screws iPod board...
- Page 6 Install console assembly 1. Install the six screws securing the console assembly to the console suport using a Phillips screwdriver. Description Console Assembly Console support Screws Install back cover 1. Route the iPod cable through the notch in the console assembly. Description Console Assembly Notch...
-
Page 7: Complete Installation
Apple Inc., registered in the U.S. and other countries. 10 Trotter Drive Medway, MA 02053 508-533-4300 • FAX 508-533-5183 • www.cybexintl.com Copyright © 2014, Cybex International, Inc. All rights reserved • LT-25116-4 A • July 2014 Page 7 of 7 www.cybexintl.com...