Advertisement
2.3
At the rear of the rack, position the rail at the same EIA location used in
step 2.2 (make sure that the locating pins seat properly). Using two silver
pan head M5 screws,
Tighten these screws with a screwdriver.
2.4
Tighten the four rail adjustment screws on the installed rail.
2.5
Repeat steps 2.2 through 2.4 for the left-hand rail.
2.6
Repeat steps 2. 1 through 2.5 if installing a second EXN2000.
FRONT
Left and Right
H1
H2
Chassis attach screws
Top rail screws
H3
H4
H5
H6
Bottom rail screws
H7
Chassis attach screws
H8
H9
attach the rail to the rack using holes H2 and H8.
Section of rack EIA rail
Rails
Locating pins
Locating pins
REAR
Left and Right
Rails
H1
Top rail screws
H2
H3
H4
H5
H6
H7
Bottom rail screws
H8
H9
1 EIA unit (1U)
5
Advertisement
