Advertisement
2
Installing the rails in an IBM 19-inch rack
Note:
Front of rack
2.1
Loosen (but do not remove) the four rail adjustment screws on each rail.
2.2
Use the figure on the next page for reference. At the front of the rack,
position the right-hand rail into the rack at the appropriate EIA location
(make sure that the two locating pins seat properly). The bottom of the rail
should line up with the bottom EIA boundary.
Note:
Using two silver pan head M5 screws, attach the rail to the front of the rack
using holes H3 and H7 . T
4
Read this document in its entirety before proceeding.
Locating pins
When installed, each EXN2000 unit will occupy a 3U space.
Rear of rack
Left rail
ighten these screws with a screwdriver.
Rail adjustment
screws
Right rail
Advertisement
