Table of Contents
Advertisement
Packaging
Contact the Fluke Customer Care before returning the instrument. A Return Merchandise
Authorization (RMA) is required prior to shipment. Additional instructions may be
available for best packaging practices.
custcarehouston@ge.com
Have the following information available when contacting Fluke Customer Care:
•
Part number
•
Serial number of the instrument
•
Your Purchase Order Number (if available)
•
The billing and shipping addresses
•
Buyer's name and telephone number
•
Invoice with Value for Customs (International)
•
Declaration by Foreign Shipper on customer's letterhead (international shipments)
Disconnecting the System
1. Remove all electrical power.
2. Remove all pressure connections. Follow proper technique to prevent loss of oil.
3. Verify that line pressure is removed.
4. Verify that all ports are sealed to minimize oil loss.
Installation of Clamps
Install the Balance Strap and Transit Clamp as shown in the Installation section.
Cleaning
Remove as much oil trapped in the Oil Catch pan and drain hoses as possible before
shipment. With the side panel doors open, use a clean paper towel to absorb any residual
oil in the Oil Catch pan.
Packaging for Shipment
The instrument will ship with oil in the system. Minimal oil will be lost if the instrument
is shipped with line pressure near zero.
1. With zero line pressure, put the Oil Isolation Valve into Isolation Mode. This will
minimize the piston motion during shipment.
2. Secure absorbent paper towels to the end of the drain hose or drain fitting with a
rubber band or tape to absorb any residual oil that may drip during shipment.
3. Enclose the instrument in a layer of plastic to prevent any contamination of the
instrument during shipment.
The instrument must be packaged appropriately for protection against the selected
method of transport.
Fluke Calibration
10311 Westpark Drive
Houston, Texas 77042-5312
USA
T: 713 975 0547
F: 502 479 6886
Differential Pressure Piston Gauge
Packaging
37
Advertisement
Table of Contents
