Table of Contents
Advertisement
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
●
In standby mode, press and holdÇon the
system until " WELCOME" is displayed.
➜
The demonstration will begin.
To deactivate the demonstration
●
Press and holdÇon the system until
"DEMO OFF" is displayed.
➜
The system will switch to standby mode.
Note:
– If you have not deactivated the demonstration,
it will resume five seconds after the system
switches standby mode.
Switching the system on
In standby/demonstration mode
●
Press STANDBY ON to switch on the last
selected source.
●
Press CD 1/2/3, TUNER or
TAPE (TAPE 1/2).
●
Press OPEN/CLOSE.
Switching the system to standby
mode
In demonstration mode
●
Press and hold Ç on the system.
In any other source mode
●
Press STANDBY ON (or B on the
remote control).
➜
The clock will appear on the display when the
system is in standby mode.
Basic Functions
Dim mode
You can select the desired brightness for the
display.
●
In any source mode (except standby mode),
press DIM MODE repeatedly to select : DIM 1,
DIM 2, DIM 3 or DIM OFF.
➜
is shown, except for DIM OFF mode.
DIM
Brightness
DIM
mode
1
normal
2
half
3
half
OFF
normal
Note:
– In standby mode, pressing DIM MODE to select
half or full brightness for clock display.
Spectrum
Analyser
off
on
off
on
13
Advertisement
Table of Contents
