Advertisement
R
epair
CAUTION: Disconnect the charger from the power source for safety before repair/ maintenance!
DC1851 has two different kinds of specifications. Distinguish them by name plate
"DC1851" and "DC1851 U" and follow each insturction. Do not use the different
parts in repair.
[1] DISASSEMBLY/ASSEMBLY FOR DC1851
[1] -1. Terminal unit and Charger case complete
DISASSEMBLING
Replace Charger case complete as drawn in Figs. 1 and 2.
Fig. 1
1. Turn Charger upside down and remove
four tapping screws.
Fig. 2
3. When replacing Charger case complete;
(1) By pinching Push mount tie, remove it from Charging circuit.
(2) Remove Connector from Charging circuit.
Charging circuit
2. Turn Charger over again and open Charger case complete
Tapping screws
Indication of DC1851
Note: Terminal unit is fully integral with Charger case complete.
Connector
from rear side.
*Open from
this side
When it is necessary to replace Terminal unit, replacing
Charger case complete and Charging condition label is required.
Push mount tie
Pinch both levers of Push mount tie
when pulling it off from Charger circuit.
P 2/ 5
Charger case complete
Terminal unit
Charger case cover
Advertisement
