Installation Tools; Option Components; Communication Modular Connector Cn1 Port 1/Port 2 - YASKAWA SI-EP3 Technical Manual

Installation Manual
*1 GA700, GA800, CR700, and CH700 drives do not use the ground wire.
*2 GA700, GA800, CR700, CH700, and HV600 drives use two screws only.
*3 LED label has transparent background and white letters. Please make sure that you use the correct label for HV600.
◆

Installation Tools

You can use these tools to install the option to the drive:
• A Phillips screwdriver or slotted screwdriver (blade depth: 0.4 mm (0.02 in), width: 2.5 mm (0.1 in))
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
*1 Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for different
screw sizes.
4

Option Components

◆
Option
A - Connector (CN5)
B - Installation hole
C - LED (NS)
*1
D - LED (MS)
*1
E - PROFINET PCB
F - Software number label
G - Ground terminal (FE) and installation hole
Option LED States on page 10
*1 Refer to
*2 Connect the included ground wire during installation. The ground wire is not necessary for installations on GA700, GA800, CR700,
and CH700 drives.
◆

Communication Modular Connector CN1 Port 1/Port 2

The communication modular connector CN1 on the option is a modular dual RJ45 female connector designated
port 1 and port 2. Port 1 and port 2 are the connection points for a customer-supplied male Ethernet network
communication cable.
YASKAWA SIEP C730600 89E PROFINET Technical Manual
Option Contents
*3
HV600
H - Port 1 LED (10/100)
I - Port 1 (RJ45)
J - Port 1 LED (LINK/ACT)
K - Port 2 LED (10/100)
L - Port 2 (RJ45)
M - Port 2 LED (LINK/ACT)
N - PROFINET cable connection
*2
Figure 4.1 Option
for more information about the LEDs.
4 Option Components
Quantity
1
1
*1
*1
*1
*1
*1
.
9