Multi-Information Display Messages - Toyota VIOS Owner's Manual

292
4-5. Using the driving support systems
■ Multi-information display messages (if equipped)
If the following situations,
multi-information display.
When the engine cannot be stopped by the Stop & Start system
●
Message
"Press Brake More
To Active"
"Non-Dedicated
Battery"
"Battery Charging"
"Stop
Unavailable"
"In Preparation"
VIOS_OM_GE_OM52L06E(TMT)_OM99V20b(TDB)_OM52L61E(TMP)_0D053(IMC)
The brake pedal is not sufficiently depressed.
 If the brake pedal is depressed further, the sys-
tem will operate.
A battery not designed for use with a Stop & Start
system may have been installed.
 Have the vehicle inspected by your Toyota
dealer.
• The battery charge may be low.
 Stopping of the engine is temporarily prohib-
ited to prioritize charging of the battery. After
the engine runs for a certain amount of time,
the system will be enabled.
• A refresh charge may be occurring
 After a refresh charge for up to an hour com-
pletes, the system can be operated.
• If displayed continuously for a long time (more than
60 minutes)
 The battery may be deteriorated. Contact your
Toyota dealer for details.
• The Stop & Start system is temporarily disabled.
 Allow the engine to run for some time.
• The engine may have been started with the hood
& Start
open.
 Close the hood, turn the engine switch off, wait
for 30 seconds or more, and then start the
engine.
• The vehicle is being driven in a high altitude area.
• The brake booster vacuum is low.
 When the brake booster vacuum reaches a pre-
determined level, the system will be enabled.
and a message may be displayed on the
Details/Actions